|
Speed up your race inspection and make it consistent!
Our Specification Check Box will help you improve
your race by providing a consistent and quick
way to inspect each car.
Our unique gauge design allows you to measure:
- Car Dimensions
– If the car fits fully inside the gauge
(with the door closed), then the car meets the
standard dimensional limits of 3" max height,
2-3/4" max width, 7" max length, and
1-3/4" min wheel spacing. If rules allow
a height greater than 3" then the height
checker can be omitted.
- Underbody Clearance
– If the bottom of the car clears the guide
rail, then the car meets the minimum 3/8"
underbody clearance. The transparent acrylic
allows you to easily see any part of the car
that will drag on the guide rail.
- Wheelbase
– If your organization has restrictions
on wheelbase, you can mark those limits on the
transparent acrylic so you can visually verify
whether or not the wheelbase restriction is
met.
- Start Pin Compliance
– Allows for checking the front of the
car to make sure that no part of it will extend
past the leading edge of the start pin or over
it. This helps ensure a fair start for all cars.
Other Checks –
The sides of the gauge are transparent acrylic
to allow you to visually check the wheels and/or
other components for compliance with organization-specific
regulations.
Other Information:
Construction
– Constructed of cabinet grade plywood and
impact and scratch resistant acrylic. Your organization
will be able to use this gauge for years to come.
Kit – The
Specification Check Box is shipped unassembled
as a kit. The kit comes with easy to follow assembly
instructions. The following tools are needed:
- Phillips head screwdriver
- Wood glue (optional)
|
